SL HYDRAULIC HAMMER

The SL range of piling hammers is designed for driving sheet piles and small bearing piles of concrete, steel or timber. The SL range is available with legs and inserts for freely suspended use or backguides for operating from a piling mast.

The hammers have the following important features:

Total control of hammer stroke and blow rate

Allows precise matching of energy to suit pile driving requirements

Double acting cylinder produces high impact energy from a short stroke to give a high blow rate

Slim design allows hammer to pass between upstanding piles

Economical – low hydraulic power requirement

Available with BSP Hydro-packs for optimum hammer performance

Hammer can be operated directly from a hydraulic crane or excavator bases

Drives piles with ultimate load bearing weight up to 1800 kN

Performance Data Ram Mass Max. Impact Blow Energy Rate at Rated Energy Operating Pressure Hydraulic Fow Required Hammer Length (with legs) Hammer Width Hammer Weight (with legs)
Model Kg KNm BPM Bar L/Min Mm Mm Kg
SL20DA 1500 20 90 170 170 4970 824 4900
SL30DA 2500 30 84 240 175 5970 824 5950

Dashboard

Above: Standard SL30 Hammer for sheet piles and ‘H’bearing piles. Inserts can be changed to drive tubes and square section piles.

Above: Wide leg assembly for SL30 driving 610 diameter tubes.